Good - Man Handle Aluminum Alloy Cave Diving Lights with 3000 Lumens Tighten Spot beam 

PRODUCTION DESCRIPTION:

1. Designed for the professionals using the cave diving lights and primary diving lights.
2. New designed and strengthened dive circuit,super stand by.
3. Micro -computer chip low voltage warning and protection.
4. Efficient Cree LED chip with life span over 50,000 hrs.
5. Durable aircraft-grade aluminum.
6. Magnetically controlled switch
7. Waterproof IP - 68 
8. Premium Type III hard-anodizing
9. Anti-roll,slip resistant body design
10. Good-man handle for easy carry.

PRODUCTION APPLICATIONS:

1. Diving
2. Adventure
3. Underwater archaeology
4. Scuba Diving
5. Underwater Light
6. Fishing and unting
7. Military & Police
8. Law Enforcement
9. Equipment overhaul
10. First Responders

PRODUCTION SPECIFICATIONS:

DLN DH30 cave diving light is designed exclusively use for underwater.This special diving light can make it under water max 150 meters.DLN DH30 cave diving light use 3 ultra bright Cree U2 LED and the max brightness is 3000 lumens.Three lighting modes (High - Low - Strobe ) can meet your different illumination needs. Magnetic switch makes the scuba divng light more easy operation and valuable illumination diving experience.

BATTERY INSTALLATION

1. Remove the top cover of the canister by turning counter-clockwise.
2. Remove used batteries and replace with fresh batteries as shown by the polarity stickers.
3. Mount the cover by turning clockwise.

BATTERY CHARGING

1.Plug the charger in the wall power socket, the indicator light is green in the free-load status.

2.Put the battery in the slot of the charger.

3.The indicator light is red if the battery is not fully charged; it will turn green after fully charged.

4.Take out the fully charged battery and use them in the canister.

ON/OFF

Push the switch forward to activate the light.

The switch will go back to original position automatically.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please remove the batteries during transportation to prevent it from misoperation.

WARRANTY RETURN POLICY

Please contact your local distributor or retailer for information on how to handle your warranty items.

REPLACEMENT PARTS

CAT#                      DESCRIPTION

DH308                   O-ring

DH309                   Lens