BATTERY CHARGING

1. Plug the charger in the wall power socket, the indicator light is green in the free-load status.
2. Plug the port of the charger in the ports on the light. (the positive and negative polar doesn’t matter, both ways work.)
3. The indicator light is red if the battery is not fully charged; it will turn green after fully charged.
4. Take out the charger and use the light.

ON/OFF

Push the switch to turn it ON.

MODES CHANGING

Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

CAUTION

If the light is not to be used for some time, remove the batteries to prevent possible leakage or corrosion. Please put the switch sleeve on light head during transportation to prevent it from misoperation.

If the switch gets stuck, please put some washing-up liquid in the slot of the switch and push the switch back and forward several times till it move smoothly again, then clean the light in the fresh water.

WARRANTY RETURN POLICY

Please contact your local distributor or retailer for information on how to handle your warranty items.

REPLACEMENT PARTS

CAT#             DESCRIPTION

DG608           O-ring

DG609           Lens