Black 860Lm Cree XML LED Submarine Scuba Diving Lights 18650 Flashlight

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.

KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.

PRODUCT SPECIFICATIONS

1. Model:D10XL Diving Light
2. Bulb:Cree XM-L U2 (Max 860 lumens) 
3. Color temperature:6500K
4. Three output levels:High> Low>Strobe
5. Runtime:High: 70min, Low: 320 min, Strobe: 150 min
6. Reflector:Glossy Aluminum reflector
7. Lens:8mm Polycarbonate Board
8. Body material:Durable aircraft-grade aluminum
9. Angle of light beam:6° hot spot, 110° periphery
10. Color:Black
11. Battery:18650 Li- ion battery *1
12. Unique design:With battery over-discharging protection, polarity reversing protection
13. Operation voltage:2.8V to 4.5V
14. Waterproof:100 meters underwater
15. Dimensions:148(length)*23(dia. of end)*50mm (dia. of head)
16. Weight:210grams (without battery); 260 grams (with battery)
17. Underwater weight:130 grams (with battery)
18. Impact resistance:1.5M

BATTERY INSTALLATION

1. Remove the tail by turning counter-clockwise.
2. Remove used batteries and replace with fresh batteries as shown by the polarity stickers.
3. Mount the tail by turning clockwise. DO NOT ACTIVATE IT YET.

BATTERY CHARGING

1. Plug the charger in the wall power socket, the indicator light is green in the free-load status.
2. Put the battery in the slot of the charger.
3. The indicator light is red if the battery is not fully charged; it will turn green after fully charged.
4. Take out the fully charged battery and use them in the diving light.

ON/OFF

Turn the tail clockwise until the light activates. DO NOT OVERTIGHTEN.

To turn the light off, back off the tail counter-clockwise until the light goes off.

Continue to back off for approximately one full turn to eliminate the possibility of the light activating accidentally in storage. For underwater use, backing off too much will allow water to enter past the o-ring.

MODES CHANGING

Successive switch ON-OFF within two seconds to cycle through high, low, strobe.